SignTorch
Artist
In Mach3, in the CONFIG menu, under PORTS & PINS
On the Motor Outputs tab set the following (click to enlarge)

On the Input Signals tab

In the CONFIG menu under MOTOR TUNING set Z as follows (hit save axis settings to save changes)

In CONFIG menu under HOMING/LIMITS, set Z Speed % to 10, check Z Auto-Zero

On the Motor Outputs tab set the following (click to enlarge)

On the Input Signals tab

In the CONFIG menu under MOTOR TUNING set Z as follows (hit save axis settings to save changes)

In CONFIG menu under HOMING/LIMITS, set Z Speed % to 10, check Z Auto-Zero
