Done Turkey

[SHHVANCE]

Tool

Plasma Cutter

Size

24 X 24

Please forgive me on this post, because I don't know correct terminology. I am trying to understand what the gentleman is saying to me. I am being told that this image attached that was originally in SVG format converted to DXF format will not work due to the lines not being connected and not being a complete image? I am looking for the image to be "cleaned up" per this gentleman, which I am interpreting are line in the image to connect so it will load into the plasma table? He also stated that the size needs to be 24 X24. Please let me know what information might be needed and I will go back to the gentleman and ask specific questions.

Thanks,

 

[SignTorch]

I edited the request title to reflect the actual subject

I deleted the DXF file because it is the same oversized file from a previous post

the SVG file in this post is different from the one in that post - this one only contains an uncompressed bitmap image - so I deleted the SVG file and replaced it with the equivalent JPG file

all you need to understand is the DXF was no good because the SVG it came from was no good as noted in the previous post

it does not need to be "cleaned up" - it needs to be redrawn for cutting at the specified size of 24" x 24"

the result will be far less detailed than the original image and somewhat different because it will be adapted so that it will cut right

and you will get a new DXF file and a new SVG file that that will cut correctly at the specified size

which will be kerf tested for <= .05" kerf - because you did not specify a specific kerf width

if it is cut correctly with <= .05" kerf width - with accurate kerf compensation - then it will come out practically identical to the new file(s)

before paying - you might want to make make sure that the gentleman uses kerf compensation and that his kerf width is <= .05" - or else he will not be able to cut the file(s) accurately at the specified size

 

[SignTorch]

- Login or Sign Up - to See More Content -

 

[SHHVANCE]

Perfect! Thank you will reach out and confirm the .05 Kerf width.

 

[SHHVANCE]

Thank you sorry took so long had to get in touch with the gentleman.

Thank you very much for your help it is greatly appreciated!

 

[SignTorch]