SignTorch
Artist
This person did not use kerf compensation - the cut does not match the drawing - the spines in the feathers are way too thin and shortened - there are some blow-outs/burn-throughs between some feathers, around the eye, and half of the chest fell out - therefore the cut does not look as good as the drawing
IF you are using CNC then YOU MUST USE KERF COMPENSATION
watch this video Kerf Compensation - VERY IMPORTANT
vinyl cutters and thin-outline-engraving are the only cutting applications that don't require kerf compensation
IF you are using CNC then YOU MUST USE KERF COMPENSATION
watch this video Kerf Compensation - VERY IMPORTANT
vinyl cutters and thin-outline-engraving are the only cutting applications that don't require kerf compensation