AChristina

[sblackburn]

A wood worker has asked me to make this out of steel for a insert on a live edge, epoxy table. This one here I was wondering if anyone could transform into DXF. I do use Vicon to those of you that know your compatible software. Any help would be great and will not go unappreciated!!

 

[SignTorch]

 

[sblackburn]

WOWW!!!!! This is so perfect and cuts great as always!!! So much appreciation from my friend that's going to use it! I'll make sure to show you a follow up picture! Gotta run for now, headed to the donation spot! Thanks again Gary! Your the best at this!